Jacket cooled submersible drainage pumps for clear water and drainage water
Submersible pumps for clear and drainage water – Bully C140
For irrigation and drainage in clear or drainage water. Cellar drainage, pumping water from sumps, pits and rooms. Also suitable for pumping discharge from hand basins, showers and washing machines, for flood relief and water removal from water courses or reservoirs.
Motor power P1
G 1¼ M
Motor power P2
Permanent or trasportable. Model with float switch control for automatic pump operation, depending on liquid level in the sump. Float switch fixation for continous operation mode.
Motor housing, screws (Stainless steel) Rotor shaft (Stainless steel, partially ceramic, coated) Pump housing, suction sieve (Glass-fibre reinforced synthetic material (composite)) Impeller (Glass-fibre reinforced synthetic material (composite))
Clear water or drainage water containing soft solids up to 10 mm spherical clearance. Max. liquid temperature: 35°C, short term up to 60°C.
Fully submersible, pressure tight electric motor. Insulation class F. Motor protection IP 68. Thermal sensors imbedded in the motor winding. Rotor shaft from stainless steel with ceramic coated sealing surface, prelubricated bearings.
10 m connecting cable permits the mobile outdoor use and an immersion depth of 7 m. Cooling jacket ensures optimum motor cooling even during sip operation. Automatic air bleed valve with additional venting screw. Detachable suction sieve for low suction of residual water. Automatic flushing if required. In combination with the special float switch (accessory), reduction of the switching height is possible.
Impeller of the Bully C140 series.
For optimum adaptation to the pump medium and operating conditions.