Motor power P1
G 2 M
Motor power P2
Collecting tank (Composite) Pump & motorhousing, impeller (Cast iron GG 25/EN-GJL-250) Cutting system (Stainless steel 1.4528 (55 HRC)) Rotor shaft, screws (Stainless steel) Seal kit (Perbonane)
Drainage water, waste water or sewage. Max. liquid temperature: 35°C, short term up to 60°C.
Single phase electric motor with thermal sensors embedded in the winding. Insulation class H. Degree of protection IP 68. Large diameter steel rotor shaft, pre-lubricated bearings.
Odour and gastight composite collection tank. Max. utility volume 11 l. WC-inlet: DN 100 horizontal, inlet height 180 mm. Vertical inlet DN 50 on the top of the tank. Air vent DN 25 vertical. Cleaning cover with screw cap.
With the advantage of a ground level direct WC connection, it is possible to place the Sanipower directly on to the back of the toilet. The reliable integrated stainless steel cutter system reduces to small pieces all soft solids from the waste water. The diameter for the discharge pipe should be 1 ¼” minimum which can be easily laid at low cost with a minimum of construction work.”
Impeller of the Sanipower series.
For optimum adaptation to the pump medium and operating conditions.
- OPEN MULTI-CHANNEL IMPELLER
For dirty and muddy media with solids.
- GRP CUTTER SYSTEM
Cutting system upstream of the impeller for grinding solids.